user manual

Security Codes (cont’d)
– 12 –
Assigning, Changing, or Deleting User Codes
4-DIGIT USER CODES
It is recommended that obvious codes
such as 1 1 1 1 or 1 2 3 4 not be
assigned.
1. Enter your Master code and press the CODE key.
2. Enter single-digit user number ('2', '3', '4', '5', '6' or '7') for which a code is to be
assigned, changed, or deleted.
3. If assigning or changing a user's code, enter the desired 4-digit code for use
by that user number. The keypad will beep once.
If deleting a user's code, perform steps 1 & 2 and stop. In a few moments the
keypad will beep once, indicating that the existing code has been deleted.
To assign your Duress code, perform the following:
Enter your [Master code] + [8] + [8] + [desired 4-digit code]. The keypad will
beep once.
The Master code can be changed by the main user of the system. To change it,
perform the following:
Enter your [Master code] + [8] + [1] + [new Master code] + [new Master code]
again. The keypad will beep once.
Important: Temporary users should not be shown how to use any system function
they do not need to know (e.g., bypassing protection zones).