user manual

Security Codes
– 11 –
General
At the time of installation, your installer programmed a personal four-digit Master
code, known only to you and yours. This code is used to perform most system
functions, including arming and disarming of the system. As an additional safety
feature, temporary user codes can be assigned (see next page) for use by those not
having a need to know the Master code. Note that the Master code remains in effect
even when other user codes are assigned.
Duress Code
Ask your installer if "Duress" is active for your system. If so, check here:
This feature is intended for use when you are forced to disarm or arm the system
under threat. When used, the system will act normally, but can silently notify the
central station of your situation, if that service has been provided.
The Duress code is defined as User number 8.
Important: The Duress code is useful only when connected to a central station.
Quick Arming
Ask your installer if "Quick Arming" is active for your system. If so, check here:
If your system supports "Quick Arming", the "#" key can be pressed in place of the
security code when arming the system. The security code is always required,
however, when disarming the system.