Heater Fan Manual

4
Model HHF565 Series – Digital TurboForce® Heater Operation
Turn heater on by pressing the Power Button (
).
The Power Indicator will illuminate and the heater
will start in the Low (
) heat level setting (Fig. 4).
This heater has two operational modes, which can be
chosen using the red switch on the back of the unit
(Fig. 3):
Continuous heating (
) – heater will run until it
is manually shut off.
AutoOff (
) mode - heater will automatically shut
off after 8 hours each time that you use the heater.
This built-in feature helps ensure that the heater is not
accidentally left on for an extended period of time.
NOTE: See the SafeGuard® Auto-Off Feature section for more information on this feature.
This heater comes pre-set from the factory with the AutoOff mode engaged. When the unit is turned on,
the AutoOff icon (
) will be illuminated on the top of the controls. All features are functional while operating in
the AutoOff mode.
Should you NOT want the heater to automatically shut off after 8 hours, switch to Continuous heating by simply
pressing the red switch on the back of the unit. Once selected, the Continuous heat icon (
) will illuminate on the
top of the control panel.
To select a Heat Setting, press (
):
1. For Low (
), this setting uses 750 watts of power
2. For High (
), this setting uses 1500 watts of power
NOTE: The Low (
) setting does not require as much electricity to operate. It is more energy efficient and may
be a better option if you are concerned about saving energy.
To use the Fan only (no heat), press the Fan button (
).
To set the thermostat, continue to press the Heat Level button (
) until Auto is illuminated. There are 4 pre-set
comfort settings from which to choose: 65°, 70°, 75°, 80°. Continue to press the Heat Level button to select your
desired room temperature setting. The heater will operate at HIGH heat in order to reach this desired temperature.
NOTE: If the Current Temperature is higher than your Desired Temperature, the heater will be off until the room
temperature falls below your desired temperature.
To set the Timer, press the (
) button to select 1, 2, 4, or 6 hour setting. The heater will run for that chosen period
in the selected mode and automatically shut off after the desired time has passed.
OPERATION
Fig. 3
Fig. 4
Fan Level
Heat Levels
Heat Temperature
SafeGuard® Auto Shut-Off
Auto Heat
Oscillation
60º 90º 120º
Power Button
Fan Button
Timer Button