Heater Manual

6
SAFETY FEATURES
CLEANING AND STORAGE
The Honeywell ComfortTemp™ 4 Ceramic Heater is equipped with several devices and features for added protection:
• A 360° tip-over switch that disables the heater if it is tipped in any direction.
• A high temperature safety sensor prevents overheating.
• This heater is also equipped with a thermal cut-off fuse that will permanently shut down the heater should
it operate at a higher than normal temperature. If activated, the unit will need to be replaced.
• This heater was built using a high temperature plastic and has a cool to touch housing and handle.
• This heater is designed with thermal insulated wiring for heat resistance and reinforced wire connections
to help protect against loose connections.
• This heater also has a SafeGuard® Auto ShutOff feature. If selected, this feature is designed to automatically
shut the heater off after 8 hours of continuous use.
• The HCE645 Series models have a SafeGuard® Motion Sensor that shuts the heater off if an object
gets too close to the motion sensor.
It is recommended that the Honeywell ComfortTemp™ 4 Ceramic Heater be cleaned at least once a month and
before off-season storage.
• Turn Off (
) and unplug heater. Allow unit to cool for 10 minutes.
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES, POLISHES
OR ANY CHEMICAL SOLUTION.
• Before storing, clean the Ceramic Heater using the above-mentioned steps. Wrap the cord around the unit.
Place in its original box and store it in a cool, dry place.
• This heater does not disassemble.
TROUBLESHOOTING
Problem Solution
If your Honeywell ComfortTemp™
4 Ceramic Heater shuts off
unexpectedly or fails to operate,
one of your heater safety features
may have been activated to
prevent overheating.
• Be sure heater is plugged in and that the electrical outlet is working.
• Check for any obstructions. If you find an obstruction, turn the heater
OFF (
) and unplug it.
• Allow the heater to cool completely, then remove the obstruction. Wait at
least 10 minutes, then re-plug the heater in and follow the OPERATION
instructions.
Model(s) Unit Dims Amps Unit Voltage Max Watts Max BTUs
HCE640 Series 7.9” L x 7.9” W x 23.4” H 12.5 120V, 60Hz 1500 5118
HCE643 Series 7.9” L x 7.9” W x 23.4” H 12.5 120V, 60Hz 1500 5118
HCE645 Series 7.9” L x 7.9” W x 23.4” H 12.5 120V, 60Hz 1500 5118
PRODUCT SPECIFICATIONS