Operation Manual

Rev 1.01 16 900.0355
01/06
Provide a 000 ~ 999 ID address and a 3-digit password to
protect the RS485 setting.
Use the arrow keys to move the cursor to RS485 and press
SET to open the RS485 Menu.
Password Setting
Before opening the RS485 menu, the camera system will
request the 3-digit password. Input the correct password,
select OK and press SET to open the RS485 menu.
Note The factory default password is 000. We
recommend changing the password
immediately to prevent tampering.
To change the password:
1. Select Password Setting in the RS485 Menu and press
SET.
2. Select each number in the 3-digit password and press
SET to enter each one.
3. Select OK and press SET to save your password and
return to the previous menu.
Address
Provide a 000 ~ 999 ID address for the device connected to
the RS485 terminal on the rear panel. The wrong ID address
setting for both controlling and receiving will cause the remote
control to cease functioning.
B-Rate
Select a Baud Rate setting. Choose from 4800 or 9600.
Note An incorrect baud rate setting will cause the
remote control to cease functioning.
For More Information
For more information about the Remote Control Operation of
this camera, go to the Honeywell website at:
http://www.honeywellvideo.com/products/
and browse the product literature to find the appropriate
Remote Control document on the HCD484E camera webpage.