Use and Care Manual

NOTE The top rail and sliding panels at each side are offset to provide the proper

pitch to the rear of 5/16”. This is necessary for the proper condensed water utilization

and drainage. If you are not using the side panels for any reason, this pitch to the rear

must be maintained.

01 Place unit on a ﬂat, stable surface. Hold the accordion panel in one hand and

gently pull back the center to free the open end.

02 Slide the free end “I” section of the panel directly into the cabinet. Slide the panel

down. Be sure to leave enough space to slip the top and bottom of the frame into the

rails on the cabinet.

03 Once the panel has been installed on the side of the cabinet, make sure it sits

securely inside the frame channel by making slight adjustments. Slide the top and

bottom ends of the frame into the top and bottom rails of the cabinet.

2.3 Install the Accordion Panels