Manualshelf

Use and Care Manual

ManualsBrandsHoneywell ManualsAir Conditioners6,000 BTU Digital Window Air Conditioner, Remote, LED Display, 4-Modes, Eco, 115-Volt/60 Hz, 250 Sq. Ft. Coverage
11121314151617181920
15
mode of operation (COOL, FAN). In this mode the temperature is set automatically
according to the room temperature (Room temperature is determined by the temperature
sensor located in the indoor unit).
Note:
You may hear a pinging noise caused by water hitting the condenser. You may hear
the thermostat click when compressor on and off. The fan may operate even when
the compressor is off.
03 and Button
Use these buttons on the control panel and remote to increase or decrease the Set
Temperature or Timer. Long press the down button 3s can override the dr mode.
Temperature range: 61°F~88°F or 16°C~31°C.
04 Sleep Button
Press the SLEEP button, all of the display lights will turn off after a while, but the Sleep”
light is always on. In SLEEP mode, the air conditioner will automatically adjust the
temperature and fan speed to make the room more comfortable during the night.
The set temperature will automatically raise or decrease based on the room temperature
and the duration of sleep
05 Eco Button
When the unit is in ECO mode, thelight will turn on. In ECO mode, the unit will turn off once
the room is cooled to the user-set temperature. The unit will turn back on when the room
temperature rises above the user-set temperature. Before the compressor starts, the fan
motor will run for a while, then it will stop for a while, and will repeat to provide a much more
comfortable feeling and save energy.
06 Power Button
Turn the air conditioner on and off.
07 Filter Button
When the Filter Check light is off, it is not necessary to press the Filter Check button.
When the Filter Check light is on, you can turn off the light by pressing the Filter Check
button. After the fan motor works for 500 total hours, the Filter Check light will turn on
to remind the user to clean the filter.
08 Timer Button
Use these buttons on the control panel and remote to set the Timer. Timer Off: The
timed stop is programmed by pressing TIMER button.
Set the rest time by pressing the button or until the rest time displayed is to your
demand then press TIMER button again.