Use and Care Manual

14
Please note (cont’d):
It is necessary to choose the place where the inlet and outlet air of the indoor unit
is even. It is necessary to avoid the places where there are other electrical products,
power switch plugs and sockets, kitchen cabinet, bed, sofa and other valuables right
under the lines on two sides of the indoor unit, and also prevent mechanical damage
from occurring.
3.1 Operating Sounds
3.2 Digital Control Panel
You may hear a pinging noise caused by water hitting the condenser, on rainy days,
or when the humidity is high. This design feature helps remove moisture and improve
efficiency. You may hear the thermostat click when the compressor cycles on and off.
Water will collect in the base pan during rain or days of high humidity. The water may
overflow and drip from the outside part of the unit. The fan may run even when the
compressor is not on.
3 USING YOUR AIR CONDITIONER
01 Digital Display:
When the timer is not in use, the operation mode and the set
temperature will be displayed. Time will be displayed under the
timer setting.
02 Mode Button:
Press the mode button to cycle through the various modes: Cool,
Dry, Fan and Auto.
Cool Mode: The cooling function allows the air conditioner to cool
the room and at the same time reduces humidity. Press the MODE
button to activate the cooling function. To optimize this function
adjust the temperature by pressing the up and down arrows and
the speed by pressing the Fan Speed button.
Dry Mode: This function reduces the humidity of the air to make
the room more comfortable. Press the MODE button to set the DRY
mode. An automatic function of alternating cooling cycles and air
fan is activated.
Fan Mode: This function only works when the air conditioner
is vented. Press the MODE button to set the FAN mode. With
pressing the FAN SPEED button, the speed changes in the
following sequence: HIGH, MED, LOW in FAN mode.
Auto Mode: In AUTO mode the unit automatically chooses the
TEMP/TIMER