Use and Care Manual

10
04 Slide the panel all the way in and repeat on the other side.
2.4 Storm Window Requirements
2.5 Placing the Unit Inside a Window
A storm window frame will not allow the air conditioner to tilt properly which
in turn will keep it from draining properly.
To adjust for this, attach a board or piece of wood to the sill. The board or wood
piece should have a depth of at least 1-1/2”. Make sure the board or piece of wood
is approximately 1/2” higher than the storm window frame. This will allow the air
conditioner to tilt enough for proper drainage.
Place the air conditioner on the sill with the bottommounting rail against its back
edge. Center the air conditioner and close the window securely behind the top
mounting rail. The air conditioner should be 3° slightly tilted to the outside area.
Use a level, about a 1/3 bubble will be the correct case slant to the outside.
(It is suggested to keep a downward angle to let accumulated rain water drain
out from the back side of the unit bottom.)
Bottom
Rail
Outside
window sill