Installation Manual

Galaxy 3 Series Installation Manual
5-2
Wiring the MAX
3
The MAX
3
unit can be connected to the control panel in one of two ways depending upon whether it is being
used in an on-line or standalone configuration. The diagrams below provides details for both configurations.
The MAX
3
relay is configured in either the NC or NO configuration depending upon the variant purchased
(MX03 - Normally Closed, MX03-NO - Normally Open).
NOTE: Fitting of an external relay may be required when using AC powered locks.
Figure 5-1. Online Connection diagram
Figure 5-2. Standalone Connection diagram
Installation (cont’d)