Installation Instructions

ManualsBrandsHoneywell ManualsBackupGalaxy 2 Series

Galaxy 2 Series Installation Manual

GSM Module (2–44+ Only)

A Dedicated GSM telecommunication interface can be connected to the Galaxy 2 series control panel to

allow an alternative communication path to the PSTN telephone line. The GSM module is installed as follows.

CAUTION: Install the control panel with the GSM Module at least 1.5 m from any wireless

peripheral device. This will avoid interference generated by the GSM. Do not

install the module in the immediate proximity of a sound source (loudspeaker, TV

set, Hi-fi chain etc.)

1. Remove all power from the control panel and remove the control panel PCB from the enclosure.

2. With the control panel PCB still removed, remove the knock-out in the top-centre of the enclosure using

broad-nose pliers, gripping the full length of the knock-out tab and bending it sharply downwards.

3. Slide the GSM antenna into the slot in the top of the enclosure and lock into place with the locking tab

provided.

4. Fit the co-axial antenna lead to the GSM module.

5. Remove the two-way jumper fitted to two of the four audio pins on the rear of the PCB.

6. Using the three stand-offs supplied with the GSM module, fit the module to the rear of the control panel

PCB, taking care to route the two power leads to the GSM power terminals on the corner of the control

panel PCB.

GSM Module

Figure 30. Location of GSM Module on Control Panel PCB

GSM

PWR

GSM

Heatsink

Underside of Control

Panel PCB

Outline of position

of GSM Module

10-way Connector

on Control Panel PCB

for GSM Module

Short Stand-off

fitted to underside

of GSM Module

Audio Pins

Long Stand-offs (2)

fitted to underside

of Control Panel PCB

Power Terminals

SIM card

slotted into

holder (note

orientation)

WARNING: Do not screw the power leads into the AUX power terminals on the control panel

PCB.

7. Screw the power leads into the two GSM power terminals observing polarity (Red lead is GSM PWR,

black lead is GSM 0V).

8. Fit a suitable SIM card into the holder on the GSM Module (see Note on SIM cards).

9. Refit the control panel PCB into the enclosure, connecting the co-axial antenna lead to the antenna.

10. All programming of the GSM module is performed in menu 56.5 of the panel programming.