Installation Instructions

35
Galaxy 2 Series Installation Manual
RF Portal (cont’d)
Plastic Base
PCB installed
in base
Antenna
(pointing vertically)
Mounting hole
(partially covered
when PCB installed)
Clip
Pillar (2 off)
Plastic support (2 off)
Mounting
hole
Mounting
Hole
Knockout
(if using an
electrical
mounting box)
Side knockout (2 off)
Figure 26. Plastic Base with PCB Installed
1. Either remove one of the knockouts in the side of the plastic base or, if fitting into an electrical box,
remove the knockout in the centre of the base (see Enclosure knockout Removal Procedure, II1-
0220).
2. Fit the two plastic supports for the PCB from the underside of the plastic base.
3. Using three screws, attach the plastic base loosely to a wall or electrical mounting box.
4. Bring in the cable from the control panel through the relevant knockout hole.
5. Firmly secure the plastic base with the three mounting hole screws.
Attaching the PCB
1. Place the PCB over the two plastic supports and the two pillars.
2. Pull back the clip then press the PCB firmly into place.
3. To allow the lid tamper switch (SW2) to function, remove the by-pass link (LK1).
4. Attach the lid tamper spring over the lid tamper switch (SW2).
Addressing the RF Portal
The RF Portal must be given a unique address before it is connected to the power supply. This address is
selected via the Address Setup Jumper and can be 4 or 5.
To set the address as 4, fit the jumper to one pin only (open) of Address Setup Jumper LK2.
To set the address as 5, fit the jumper across the two pins (shorted) of Address Setup Jumper LK2.