Installation Instructions

Galaxy 2 Series Installation Manual

Panel Mounting (Metal Box)

Installation Kit

The Galaxy 2 Series metal box comes with an installation kit. It contains two No.8 x 12 mm self-tapping lid

screws, 6160 Text Programming Overlay, two battery leads (one red and one black), 10 mm cable staple and

24, 1K resistors.

WARNING: The lid of the metal box must not be removed before isolating the mains supply.

Illumination of the keypad power LED indicated the presence of a.c. mains supply.

Removing and Installing the Enclosure Lid

1. Remove the two self-tapping screws that secures the lid to the enclosure base.

2. Slide the lid forward on the locating slots then lift clear.

3. To install the lid, simply reverse the process.

NOTE: The top self-tapping screw activates the Lid Tamper Microswitch.

Figure 17. Galaxy 2-20 Series Metal Box Layout

Panel Mounting (cont’d)

Enclosure

Earth

Connection

Transformer

Lid Tamper

Microswitch

Mains

Terminal block

with 200mA Fuse

Mains Cable

Entry Hole

NOTE: Figure 17 shows the Galaxy 2-20 in the metal box. The procedure to remove and install the Galaxy

2-44+ is identical to the 2-20.