Installation Instructions

Galaxy 2 Series Installation Manual

Option 63 - Options

This menu has one sub-section:

1 = Groups

There are three sub-options:

1 = Group Mode

This option enables group mode. When enabled, each group on the system will behave as an independent

area that can be separately set and unset. There are two settings:

0 = Disabled

1 = Enabled

If a group mode is switched off, the system will behave as though all zones, users and outputs are in group 1.

63 - Options

GROUPS 123GROUPS 123

GROUPS 123

Set YNNSet YNN

Set YNN

2 = Common Group

Group 4 is intended to be a group that will cover a common access area (such as an entrance foyer). This

group will set and unset automatically depending on the state of the other individual areas. When all the other

individual areas are set, the common group will set along with the last group. As soon as any of the individual

groups are unset, the common group will unset. In order to determine which individual groups need to be set

before the common group sets, the group map in this option can be programmed. The screen is as shown

below. Pressing the appropriate group number toggles the group status between Y and N. A Y under a group

number means that that individual group needs to be set before the common group can set.

3 = Comms Set Map

This option selects which groups must be set before intruder communication can be enabled. This means either

full set, night set or part set. The screen should appear as follows:

GROUPS 1234GROUPS 1234

GROUPS 1234

Set NNNNSet NNNN

Set NNNN

This option only affects Set, Intruder, Confirm, Omit, Abort and the appropriate restore signals. All other

signalling is not part of the Intruder comms system.