Installation Manual

411UDAC Document #51073 Rev. D 12/09/2008 P/N 51073:D 57
Central Station Communications
Where:
SSS or SSSS = Subscriber ID
FA = Fire Alarm (1st digit)
FA2 = Fire Alarm (2nd digit)
Z = Channel/Input Number
RFA = Fire Alarm Restore (1st digit)
RFA2 = Fire Alarm Restore (2nd digit)
TZ = Zone Trouble (1st digit)
TZ2 = Zone Trouble (2nd digit)
RTZ = Zone Trouble Restore (1st digit)
RTZ2 = Zone Trouble Restore (2nd digit)
TS = System Trouble (1st digit)
TS2 = System Trouble (2nd digit)
RTS = System Trouble Restore (1st digit)
RTS2 = System Trouble Restore (2nd digit)
P = AC Loss (1st digit)
P2 = AC Loss (2nd digit)
RP = AC Loss Restore (1st digit)
RP2 = AC Loss Restore (2nd digit)
V = Fire Supervisory Condition (1st digit)
V2 = Fire Supervisory Condition (2nd digit)
RV = Fire Supervisory Condition Restore (1st digit)
RV2 = Fire Supervisory Condition Restore (2nd digit)
X = Test Report (1st digit)
X2 = Test Report (2nd digit)
Y = Trouble corresponding to the following:
1 = Not Used
2 = Not Used
3 = Not Used
4 = Telco Primary Line Fault
5 = Telco Secondary Line Fault
6 = Not Used
7 = Not Used
8 = Not Used
9 = Not Used
A = Communication Failure Primary Number
B = Communication Failure Secondary Number
C = Not Used
D = Not Used
E = Not Used
F = System Off Normal
UD = Upload/Download (1st digit)
UD2 = Upload/Download (2nd digit)
Note that for Expanded Reporting, the digital communicator automatically adds the digit corresponding to the
Channel/Input number, and the second digit corresponding to any system trouble condition. Only the first digit
shown in Table 3-3 and Table 3-6 is programmable.
TABLE 4-2: Format Selection Address Explanation