Installation Instructions

- 2 -
3. Mount the Sensor
[A] = Fixed mounting holes
[B] = Adjustable mounting slots from 61mm-85mm (2.4”-3.3”)
[C] = Tamper hole
*This accessory is not covered by the approval.
4. Wire the Sensor
Wiring Details
•
Observe proper polarity.
• If not using the integrated EOL resistors, set all switches to OFF.
• If using the integrated EOL resistors:
1. Connect the sensor to the panel.
2. Set the appropriate Alarm, Tamper and Trouble/Anti-mask EOL
DIP switches to ON. (see Step 5 ).
Notes:
• Consult the Control Panel manual to determine
proper EOL selection.
• The Alarm, Tamper and Trouble/anti-mask EOL
settings must each only have one switch ON.
• The EOL values should be set at the same time.