Installation Instructions

39evohome Installation Guide
To add or replace a zone device
such as a Radiator Controller
or Temperature Sensor
1
On the evohome Controller press and
hold “Settings” for 3 seconds
2
Press the green tick
3
Press ZONE CONFIGURATION
4
Select the required zone
5
Press RF DEVICE BINDING then follow
the instructions to bind the device.
To replace a system device such as a
Wireless Relay Box, System Valve, or
Hot Water component
1
On the evohome Controller press and
hold “Settings” for 3 seconds
2
Press the green tick
3
Press SYSTEM DEVICES
4
Select the type of device and follow the instructions to bind.
If the device you are
replacing is no longer
required in the system
remove the power
as it may still try to
communicate with the
system.
!
If the device you are
replacing is no longer
required in the system
remove the power
as it may still try to
communicate with the
system.
!
Adding or replacing components in an existing system