Installation Instructions

31evohome Installation Guide
Battery Powered Wireless Devices
Battery powered devices need to be put into
test mode to send and receive a test signal:
Radiator Controller (HR92)
1
Press the button, the zone name is displayed
2
Press and hold the button again for 5
seconds, the display should say BIND
3
Turn the dial to display RF CHECK
4
Press the button, the display
should flash CHECKING
5
Press the button again, the display should
flash SIGNAL and will display a signal strength
bar and a rating from 1 (poor) to 5 (excellent) – 0
means the Radiator Controller has not received
a test signal from the evohome Controller.
6
To exit test mode turn the dial to exit and press the
button. It will also exit automatically after 10 minutes.
1
2
3
4
PRESS
AND HOLD
4 SEC
"RF CHECK"