Installation Instructions

13evohome Installation Guide

Step 3: Power up and

bind devices

If you bought a Connected Pack only — your devices are already bound. Go

to Step 4.

If you bought an unbound evohome Controller, plus other un-bound

devices and are using ‘Guided Conﬁguration’ follow the instructions on

your evohome Controller screen and use this section to put the devices into

binding mode.

If you bought a Connected Pack, plus other un-bound devices, you need to

power up all devices and then bind them to the evohome Controller using

the ‘Installation Menu’. It may be easier to power up and bind some devices

while they’re close to the evohome Controller – you can install them in their

assigned zones later.

Follow the instructions for the device(s) you’re going to bind. When you

bind a device to the evohome Controller the devices permanently store the

connection and there should never be a need to rebind them again – even

after a power cut.

In this section

Radiator Controllers (HR92) 14

Wireless Cylinder Thermostat (CS92) 16

Wireless Relay Box (BDR91) to control a Boiler 18

OpenTherm Bridge (R8810) 19

Wireless Relay Box (BDR91) to control a Zone Valve 20

Radiator Controller (HR80) 22

Underﬂoor Heating Controller (HCE80 or HCC80) 24

Mixing Valve Controller (HM80) 27