User Manual

ManualsBrandsHoneywell ManualsElectronicsWireless Charge Rack

Installing the Charge Rack

4-11

DIAD 6 Charge Rack Manual

New Charge Rack Installation

• Do not install near other equipment or machines that routinely produce conduc-

tive dust.

• DIAD 6 battery charging can be negatively affected by temperature extremes.

• A fully loaded DIAD 6 charge rack weighs 107.5 lbs (48.8 kg). The DIAD 6

Charge Racks must be installed in a location that will support the weight of the

racks when fully loaded.

• The Mounting Frame MUST be used to secure the DIAD 6 Charge Rack to the

wall to prevent possible damage to the Charge Rack. Failing to use the Mount-

ing Frame could result in issues charging/powering terminals within the rack.

• The DIAD 6 Charge Rack should be installed in an interior location that is not

subject to excessive dust or moisture and is out of direct sunlight.

• The ambient temperature of the mounting location for DIAD 6 Charge Racks

must remain between 32° F and 95° F (0° C and 35° C). Charging is not guar-

anteed if the ambient temperature exceeds these limits.

This section describes how to mount the DIAD 6 Charge Rack where no rack was previously

installed. The DIAD 6 Charge Rack is designed for horizontal wall mounting only. The mounting

frame attaches to a wall that can structurally support the DIAD 6 Charge Rack. The mounting

frame must be attached to structural supports within the wall. The DIAD 6 Charge Rack fastens to

the mounting frame.

Required Parts and Hardware

All parts required to assemble DIAD 6 Charge Rack systems are pre-package as assembled

groups or as bagged parts.

Item (Quantity)

Part Number

DIAD 6 Charge Rack Kit (1)

(kit does not contain 4 mounting bolts)

CN85-CR (Wired)

CN85-WCR (Wireless)

Side Guard Kit (1)

99EX-CR-NRGUARDKIT

Wall Mount Frame (1)

By Local P.E.

Channel Frame 3/8” Nut w/retainer (4)

By Local P.E.

1/8” - 16 1” Hex Head Screw (4)

By Local P.E.

3/8” - 2.5” Hex Lag Screw (6)

By Local P.E.

5/16” Toggle Bolt (4)

By Local P.E.

0.375”x1.6”x 0.125” Fender Washer (4)

By Local P.E.

0.265”x8.875”x 0.035” Fender Washer (4)

By Local P.E.