User Manual

Installing the Charge Rack

4-4

DIAD 6 Charge Rack Manual

• The DIAD 6 Charge Rack must be installed in an interior location or climate-

controlled environment that is not subject to excessive dust or moisture and is

out of direct sunlight.

• The ambient temperature of the mounting location for DIAD 6 Charge Racks

must remain between 32° F and 95° F (0° C and 35° C). Charging is not guar-

anteed if the ambient temperature exceeds these limits.

Required Parts and Hardware

The DIAD 6 Charge Rack Kit contains a Charge Rack and two side guards with sheet metal

screws. The kit does not contain the four mounting bolts required. Use the existing bolts from

your uninstall. The DIAD 6 Charge Rack is designed to mount on the previously installed DIAD 5

mounting frame.

Item (Quantity)

Part Number

DIAD 6 Charge Rack (1)

CN85-CR (wired)

CN85-WCR (wireless)

Side Guard Kit (1)

99EX-CR-NRGUARDKIT

Tools

Before attempting to install the DIAD Charge Rack, you must have the following tools:

• 9/16” Wrench or socket

• Tape Measure

• Level

• Large Straight Blade Screwdriver

• Small Straight Blade Screwdriver

• Phillips Screwdriver

Replacement Installation Procedure

1. Locate the existing DIAD 5 Charge Racks within the facility. Ensure the Charge Rack is

empty of DIAD units. Have UPS operations remove all existing DIAD 5s. Locate the ON/

OFF toggle switch on the Charge Rack and turn to OFF. Unplug unit from electrical outlet.

Disconnect all data cables from the unit using a small straight blade screwdriver and cover the

cable ends with electrical tape.

2. Remove the top cover from the Base Station by unsnapping cover from slots located near rear

wall of Base Station. For stacked multiple Base Station mountings, remove mid cover and

upper Base Station and pry loose.

3. The following steps are easier to perform with two people. One person should hold the exist-

ing Base Station while the second person loosens the four 3/8-16 x 1” Hex Head Screws and

3/8” x 1 flat washers from the Base Station. Screws and washers are located on the vertical