Portable Evaporative Air Cooler OWNER’S MANUAL Read and save these instructions before use Model: CO25MM With Metal Stand Power rating: 190 Watts Voltage rating: 220 Volt, 50 Hz Made in P.R.C.
This page is intentionally left blank
INDEX Read all instructions carefully before setting up and operating the cooler, and keep this instruction manual for future reference. This manual is designed to provide you with important information needed to setup, operate, maintain, and troubleshoot your cooler. Failure to follow these instructions may damage and/or impair its operation and void the warranty. SECTION PAGE THANK YOU ...............................................................................................................
THANK YOU Congratulations on your purchase of this versatile Honeywell Evaporative Air Cooler. For optimum cooling from your cooler, please fill the water tank to maximum level and load ice inside the ice compartment before you turn on your air cooler. Cooler Location (Important - Please Read!) The cooler in front of an open door or window. Ensure that there is adequate cross - ventilation in the room by leaving a door or window open opposite the cooler.
USER TIPS Energy efficient, No compressor Honeywell Evaporative Air Coolers are built to maximize energy efficiency and keep costs low. Warm air is drawn into the cooler through a dust and odor-reducing carbon filter and enters the Honeycomb Cooling Media. Water pumped from the tank pours over the honeycomb media. As the warm air passes through the media, the water absorbs the heat, naturally cooling and humidifying the air. A fan propels the cooled air out into the room.
USER TIPS The recommended maximum relative humidity level is 60% or less, which allows a noticeable temperature decrease. The temperature decrease will be greater in drier climates because higher evaporation occurs when the humidity is low. The evaporative air cooler should not be used in enclosed spaces. It must be kept level and there must be water in the water tank. The room should have doors and windows opened to allow free air flow.
SAFETY READ AND SAVE THESE INSTRUCTIONS: When using electrical appliances, basic safety precautions should always be followed: • Your cooler runs on 220 Volt AC, 50 Hz current. Check the household voltage to ensure it matches the appliance's rate specification. • Before operating the product remove it from its packaging and check that it is in good condition. • DO NOT operate any product with a damaged cord or plug. We recommend not using an extension cord with this appliance.
SAFETY • DO NOT attempt repair or adjust any electrical or mechanical functions of the cooler, as this may void the warranty. • DO NOT cover the air inlet or outlet on the appliance as this may cause motor damage. • DO NOT insert or allow objects to enter any ventilation or exhaust opening as this may damage the product and could cause an electrical shock or fire. • DO NOT operate with the Honeycomb media removed as this will overload and damage the motor.
PARTS DESCRIPTION - METAL STAND METAL STAND Parts List: Qty Steel angle Pole 1 (755 mm) Pole 2 (600 mm) Pole 3 (476 mm) Pole 4 (286 mm) Pole 5 (with rating label) Universal wheel (without braking) Universal wheel (with braking) Bolt 3/8” - 16 X 75 Bolt 3/8” - 16 X 50 Bolt M8 X 35 Bolt M8 X 15 Acorn nut M8 Acorn nut M10 Nut M8 Spring washer Black silicon pad S17 spanner S14 spanner 2 PC 4 PC 2 PC 2 PC 2 PC 1 PC 2 PC 2 PC 8 PC(Plastic bag 130 X 100) 6 PC(Plastic bag 130 X 100) 8 PC(Plastic bag 130 X 100) 4
ASSEMBLING INSTRUCTIONS METAL STAND 1 4 3 2 8
ASSEMBLING INSTRUCTIONS AIR COOLER 6 5 9
PARTS DESCRIPTION - AIR COOLER 1 11 2 3 10 9 4 5 13 8 1 2 3 4 5 6 7 10 Tray for Tools Side Panel Control Panel Horizontal Louvers Water Tank Water Inlet Valve Removable 7 6 8 Water Level Indicator 9 Lever for Horizontal Louvers 10 Back Panel 11 Water Inlet Cover 12 Water Drain Plug 13 Rear Grill Removal Screws 12
USE & OPERATION CONTROL PANEL POWER SPEED SWING COOL 11
USE & OPERATION CONTROL BUTTONS POWER Connect to the power supply to turn ON/OFF the product. Whenever you turn ON/OFF the product the setting of SPEED, SWING and COOL will depends on the state of its own button. POWER SPEED Switch the fan speed between Low and High level. COOL Turn the Cool knob to ON to start the cooling. It takes a few minutes to obtain the full effect from this mode. SWING Vertical Louvers Turn the SWING knob to 'ON'. The louvers will begin to move from right to left automatically.
USE & OPERATION FILL WATER ( Continuous Water Supply Connection) • Connect a garden hose connector to the water inlet valve, Make sure garden hose connector is well screwed with water inlet valve. • Connect water supply to the garden hose, and turn on water supply. • Water inside the tank will automatically refill once, it reaches the Min. Level. Water inlet valve • Similarly, the water supply to the tank will stop, once the tank is full, and reaches Max. Level.
CLEANING & MAINTENANCE IMPORTANT • The cooler is supplied with Honeycomb cooling media. • The cleaning frequency for the Honeycomb media depends on local air and water condi- • • • • tions. In areas where the mineral content of water is high, mineral deposits may build up on the honeycomb cooling media and restrict air flow. Draining the water reservoir and refilling with fresh water at least once a week will help reduce mineral deposits.
CLEANING & MAINTENANCE DRAINING AND CLEANING THE WATER TANK • Turn the power "off" and disconnect the unit from power supply. • Move the unit to a location where it can be drained and remove the • • drainage tube/cap (see parts description on page 10, No.12). Once the tank is empty, refill with clean water and drain it again. This should be repeated weekly to maintain the integrity of the unit and to remove particles filtered from the air. Once the tank is clean, refill the water tank.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION No discharge of air Cord is not plugged in. Supply switch in ON. Power is not on. Turn the unit ON by pressing buttons on the control panel. Pump is not turned ON. On Control Panel, Turn COOL FUNCTION to “ON” Low or no water in tank, when COOL is selected. Refill water tank. Damaged Pump or Calcium deposits on blower. Contact service center. When the Cooler is new.
TECHNICAL SPECIFICATIONS MODEL NO. Voltage Frequency Wattage Water Tank Capacity Cooling Media Product Dimension Net Weight CO25MM 220V 50Hz 190 Watts 25 Litre Honeycomb 610(L) x 480(W) x 825(H) 21 Kg NOTE This unit is supplied with three (3) Honeycomb Cooling Media’s located on the back & two sides.
ELECTRICAL WIRING DIAGRAM 220V 50Hz 18
: © 2012 AirTek International Corporation Limited The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representation or warranties with respect to this product. Manufactured by AirTek International Corporation Limited.
