Owner's Manual

Page 2 of 6 — HON-62044:A • 08/31/2020
ELECTRICAL SPECIFICATIONS
Table 1 lists the electrical specifications for each Honeywell BDA models.
Specification
HON-BDA400-D5-1A HON-BDA400-D5-1B HON-BDA800-D5-1A HON-BDA800-D5-1B
HON-BDA7800-D5-2A HON-BDA7800-D5-2B
Frequency Range (MHz) DL: 406.1-512
UL: 402-512
DL: 406.1-512
UL: 402-512
DL: 851-862
UL: 806-817
DL: 851-862
UL: 806-817
U L 1 : 7 9 9 - 8 0 5
UL2: 806-817
DL1: 769-775
DL2: 851-862
UL1: 799-805
UL2: 806-817
DL1: 769-775
DL2: 851-862
FCC ID 2AHPSB400M3A 2AHPSB400M3B 2AHPSB800M3A 2AHPSB800M3B 2AHVPSB7800M3A 2AHVPSB7800M3B
Amplifier Composite RF
Output Power dBm (W),
Max.*1
DL: 37dBm (5W)
UL: 37dBm (5W)
DL: 37dBm (5W)
UL: 37dBm (5W)
DL: 37dBm (5W)
UL: 37dBm (5W)
DL: 37dBm (5W)
UL: 37dBm (5W)
DL: 40dBm
(10W)
Combined
700+800MHz
UL: 37dBm (5W)
DL:40dBm
(10W)
Combined
700+800MHz
UL: 37dBm (5W)
Duplexer Insertion Loss
dB (typ.)
2.5–6 dB 2.5–6 dB <2.5dB <2.5dB <2.1dB <2.1dB
Gain and Power Ripple
within the rated Pass-
band dB (typ.)
<3dB <3dB <3dB <3dB <3dB <3dB
Selectable Channel
Bandwidth for Each
Channel (kHz)
12.5, 25 12.5, 25, 150,
250, 500
12.5, 25 12.5, 25, 150,
250, 500
12.5, 25 12.5, 25, 150,
250, 500
Channel Filter Capacity
(Downlink + Uplink)
32 + 32 32 + 32 32 + 32 32 + 32 64 + 64 64 + 64
Selectable Channel Fil-
ter Latency / Group
Delay Per Channel
(usec.)
12, 20, 48 12, 20, 48 12, 20, 48 12, 20, 48 12, 20, 48 12, 20, 48
Maximum System Gain
(typ.) dB
92 92 92 92 92 92
Gain Adjustment Atten-
uation Range in 1dB
Steps (dB)
0-35 0-35 0-35 0-35 0-35 0-35
Power Adjustment
Range 1dB Steps(dB)
0-15 0-15 0-15 0-15 0-15 0-15
Intermodulation (IM3) <-15dBm <-15dBm <-15dBm <-15dBm <-15dBm <-15dBm
Amplifier Noise Figure <4dB <4dB <4dB <4dB <4dB <4dB
Maximum RF Power
Input for Rated IM3
-20dBm -20dBm -20dBm -20dBm -20dBm -20dBm
Absolute Maximum
Input Power
0dBm 0dBm 0dBm 0dBm 0dBm 0dBm
Impedance W505050505050
RF Connector Type N-Female N-Female N-Female N-Female N-Female N-Female
Supply Voltage VDC 28.5V DC 28.5V DC 28.5V DC 28.5V DC 28.5V DC 28.5V DC
Power Consumption
Under Maximum Load
<90W <90W <90W <90W <150W <150W
Warning: These devices are NOT CONSUMER devices. The devices are designed for installation by FCC LICENSEES and QUALIFIED
INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee to operate this device. You MUST register Class B
signal boosters (as defined in 47 CFR 90.219) online at www.fcc.gov/signal-boosters/registration. Unauthorized use may result in significant
forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.
Note: Changes or modifications not expressly approved by the Manufacturer, responsible for compliance, could void the user’s authority to
operate the equipment.
Table 1 BDA Electrical Specifications
firealarmresources.com