Wireless System Installation Instructions

Français : voir la page 17 • Español: vea la página 32

3 69-2090EFS—07

Install batteries in wireless devices

When system wiring is complete and TrueZONE panel is configured for RF,

install batteries in all devices. Make sure batteries are inserted properly (see

illustrations below).

Link all devices to wireless network

Make sure the Connected light on the

wireless adapter is flashing green.

If the light stops flashing before you have

linked all devices, press connect again.

MCR33901

Press connect

Flashing status light times out after 15

minutes of inactivity. Press connect again if

necessary.

Continued on next page >>

If light does not flash, another EIM/wireless

adapter may be in wireless setup mode. Exit

wireless setup at the other EIM/wireless adapter.

M28474

Thermostat

M28472

M28473

Install quick reference cardInstall 2 fresh AA

batteries

MCR32939

Remote control (optional) Outdoor air sensor (optional)

M28444

Install 3 fresh AA

batteries

Install 2 fresh AA

lithium batteries

Programmable models only