Remote & Wireless Outdoor Sensor Installation Instructions

Install batteries in wireless devices
1
Make sure batteries are inserted properly (see polarity marks on illustrations
below).
Link devices to wireless network
2
Press the
CONNECT
button at the EIM or
wireless adapter and wait for green
flashing light to begin linking devices to
the wireless network (see page 3).
If the light stops flashing before you
have linked all devices, press
CONNECT
again.
Press
CONNECT
Remote control Outdoor air sensor
Install 3 fresh AA
batteries
Install 2 fresh AA
lithium batteries
Flashing status light times out after 15
minutes of inactivity. Press
CONNECT
again if
necessary.
Continued on next page >>
RedLINK™ Installation Guide (Wireless Accessories)
2
If light does not flash, another EIM/wireless
adapter may be in wireless setup mode. Exit
wireless setup at the other EIM/wireless
adapter.