Users Manual

ALL

EFFECTIVITY

Page 5-39

22 Apr 2019

23-15-49

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL

ASPIRE-400

(d) EOT (end of block).

(5) With the following constraints:

(a) A block comprises one page of display data

(b) A record uses the associated authorized set of ISO 5 characters

NOTE: There is no specific inter-word timing for transmission of the 429

words of a block to the CFDS.

F. Type 1 Configuration Report Format

(1) The SDU reports the SW part number as "Invalid" under the following circumstances:

(a) Either primary or secondary images are corrupt

(b) The active software part does not match the expected configuration.

(2) The ACD reports the Software Part Number, Hardware Part Number and Serial Number

as "Not Available" for any external LRU (except the SCM) when the SDU has not yet

received configuration data from the LRU

(3) The ACD reports the following information provided by the SCM as "NOT AVAILABLE," if

it cannot be read from the SCM:

(a) SCM Hardware Part Number

(b) SCM Serial Number

(d) IMSI Channel 2.

(4) When ORT configured to CFDS Type 1, the ACD provides the Software Location ID and

software location description based on ORT setting and configuration strapping in the

configuration report to the CFDS.

(5) When ORT configured to CFDS type 1, the Configuration Data, sent from the SDU to the

CFDS, is populated with the configuration information of each component, as shown in

Figure 5-3:

DRAFT

3rd rvw Draft as of:

29 January, 2020