Users Manual

ALL
EFFECTIVITY
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Page 5-31
22 Apr 2019
23-15-49
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
ASPIRE-400
(i) Log on after being logged out by GDGW.
NOTE: If multiple reasons are applicable, the first applicable one should be
used.
(2) In the AAP logon request, the ACD ADGW populates the following information identifying
the SATCOM configuration:
(a) The class of terminal based on ORT settings
(b) The Satellite ID
(c) SBB Type approval code retrieved from the ORT
(d) SDU HW and SW part numbers
(e) Antenna HW and SW part numbers
(f) SDU-vendor
(g) System designator (short descriptive name)
(h) Aircraft tail number
(i) Aircraft type
(j) Flight ID.
NOTE: Not all this information is available in all installations.
(3) When notified of a successful AAP login, the ACD configures the following based on the
direction from the GDGW:
(a) ac_aap_t1 forward message timeout period
(b) ac_aap_t2 acknowledgement timeout period
(c) ac_aap_t3 range of randomized reconnection timer
(d) ac_aap_t4 non-preferred service timer.
(e) ac_aap_t5 IP recovery timer
(f) ac_aap_t6 DNS server check timer
(g) ac_aap_r1 keep alive retry times
(h) ac_aap_r2 max. keep alive retry attempts
(i) ac_aap_r3 max. log out retry attempts
(j) ac_aap_r4 max. Air-to-Ground message attempts
AND
(k) Stores in non-volatile memory for use in next logon.
(4) The ACD:
(a) Temporarily blacklists the GDGW.
(b) Re-attempts log on.
(5) When the ACD ADGW receives one of the following login failure response codes from
the GDGW:
(a) 1001 0001 no service provider for this aircraft
(b) 1001 0010 no service provider for any aircraft
DRAFT
3rd rvw Draft as of:
29 January, 2020