Users Manual

ALL
EFFECTIVITY
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Page 5-21
22 Apr 2019
23-15-49
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
ASPIRE-400
(c) +CMGF (Message Format).
NOTE: These AT commands are mandated in A781 but are not supported
since SBB does not support SMS.
(4) The PIESD rejects the following SMS Service - General Configuration AT response when
it is received is +CMS ERROR (Message Service Failure Result Code)
(5) The PIESD rejects the following Message Configuration AT commands if they are
received at the PIESD user interface of the SDU:
(a) +CSCA (Service Centre Address)
(b) +CSMP (Set Text Mode Parameters)
(c) +CSAS (Save Settings)
(d) +CRES (Restore Settings).
(6) The PIESD rejects the following Message Receiving and Reading AT commands if they
are received at the PIESD user interface of the SDU:
(a) +CNMI (New Message indications to TE)
(b) +CMGL (List Messages)
(c) +CMGR (Read Messages).
(7) The PIESD rejects the following Message Sending and Writing AT commands if they are
received at the PIESD user interface of the SDU:
(a) +CMGS (Send Message)
(b) +CMSS (Send Message from Storage)
(c) +CMGW (Write Message to Memory)
(d) +CMGD (Delete Message).
(8) The PIESD rejects the following General AT commands if they are received at the PIESD
user interface of the SDU:
(a) +CSCS (Select TE Character Set)
(b) +CMUX (Multiplexing mode).
(9) The PIESD rejects the following ITU-T V.25TER TE-TA Interface AT commands if they
are received at the PIESD user interface of the SDU:
(a) S0 (Number of rings until auto answer)
(b) S2 (Escape character)
(c) S3 (Command line termination character)
(d) S4 (Response formatting character)
(e) S5 (Command Line editing character)
(f) S6 (Pause before blind dialing)
(g) S7 (Connection completion timeout)
(h) S8 (Comma dial modifier time)
(i) S10 (Automatic disconnect delay)
(j) S12 (Escape guard time - 0.02s)
DRAFT
3rd rvw Draft as of:
29 January, 2020