Installation Guide

3
NOTE: Deadbolt Latch Set is shipped with the backset set at 23/8” (60mm)
Measure the backset (backset is distance between edge of the door and the
center of Lock).
1. TO CONVERT FROM 23/8” (60mm) BACKSET TO 23/4” (70mm) BACKSET
a. Hold latch with numbers facing forward and thumb pressing on the bolt (Figure 1a).
 
 
indicator (Figure 1c).
2. TO CONVERT FROM 23/4” (70mm) BACKSET TO 23/8” (60mm) BACKSET
a. Hold latch with numbers facing forward and thumb pressing on the bolt (Figure 2a).
 
 
position indicator (Figure 2c).
NOTE: Do not extend Cylindrical Cover past 23/4” (70mm)
Figure 2a Figure 2b
Your latch is now set 2-3/8” (60mm) backset
Cylindrical Cover Extension Plate
2-3/8”
(60mm)
2-3/8”
(60mm)
Figure 2c
Figure 2d
Figure 1a Figure 1b
Figure 1c
Your latch is now set 2-3/4” (70mm) backset
Cylindrical Cover Extension Plate
2-3/8”
(60mm)
2-3/8”
(60mm)
2-3/4”
(70mm)
Figure 1d
ADJUSTING DEADBOLT LATCH SET