Install Manual

Table Of Contents

Generator Placement

18 Installation Guidelines for 60 Hz Air-Cooled Generators

Fascia Installation (If Applicable)

• Locate the four threaded black rubber bumpers

supplied with the loose parts. (See Parts Shipped

Loose.)

• See Figure 4-3. Remove the bumpers from the

bag and screw them into threaded holes located

inside the end pieces of the fascia (two each)

opposite one another (A).

Figure 4-3. Fascia Installation

• Snap one of the end pieces into one of the front/

rear pieces of fascia. Repeat this action with the

other two remaining pieces of fascia (B).

NOTE: Do not assemble all four pieces together at this

point.

• Place both assemblies at the base of the generator

and fit the rubber mounts into the lifting holes in the

generator base (C).

• Once aligned, snap together the two remaining

connection points.

000614