Install Manual

Unpacking and Inspection
Installation Guidelines for 60 Hz Air-Cooled Generators 9
Intake Side Panel Removal
See Figure 2-5. The intake side panel (A) must be
removed to access the battery compartment, fuel
regulator, and sediment trap.
1. Raise lid and remove front panel.
2. Use a hex key to remove two mounting screws (B)
and hex screw on the L-bracket (C).
3. Lift intake panel up and away from the generator.
4. Perform a visual inspection for any hidden freight
damage. Contact the freight carrier if damage is
present.
NOTE: Always lift intake side panel straight up before
pulling away from enclosure. Do not pull panel away from
enclosure before lifting up (D).
Figure 2-5. Intake Side Panel Removal
See Figure 2-6 and Figure 2-7 for customer connections
and loose parts location. Figure 2-9 illustrates parts
shipped loose.
Figure 2-6. Customer Connection Area and Loose
Parts Location
Rear Connections
Figure 2-7. Rear Connections
NOTE: The generator is equipped with a Wi-Fi module.
Refer to the Wi-Fi module owner’s manual for further
instruction.
D
002961
B
A
C
A Customer electrical connection area
(behind access panel)
B Fuel regulator with sediment trap
C Battery compartment (battery not supplied)
D Positive (+) and negative (-) battery cables
E Location of “Loose Shipped Parts”
001800
A
B
D
C
E
A Wi-Fi module
B Main AC/Control wiring hole for 1-1/4 in conduit
C Main AC/Control wiring hole for 3/4 in conduit
D Fuel connection hole
E Auxiliary shutdown switch
001802
D
C
B
A
E