Digital Steel Security Box Manual

SETUP & OPERATION
STEP 1: OPEN SECURITY BOX & INSTALL BATTERIES
For your convenience, we have included 4 “AA” Batteries that provide the power
for the electronic keypad. These must be installed before using your box. If
your safe is locked, you may use the Emergency Key to open it.
1. Remove the Black Emergency Key Cover.
1.
2. Insert the Emergency key and turn ¼ turn to
the left (counterclockwise).
2.
3. Turn the Open/Close knob ¼ turn to the left
(counterclockwise) and open the lid.
3.
4. Remove the Battery Compartment cover by
pushing in and sliding down.
4.
5. Install the batteries as pictured on the inside
of the Battery compartment.
5.
6. Once the batteries are properly installed,
replace the battery compartment cover.
Close Lid, Return Knob & Key to “Locked”
position and replace Emergency key cover.
6.
NOTE: If batteries are removed or fail, the keypad memory will NOT be erased
and the active programmed code will still work once power has been restored.
SETUP & OPERATION
STEP 2: OPEN THE BOX AND RESET PASSCODE
The preset factory user code is 3  .
1. Enter the factory preset code and you will
see the LED light turn green.
1.
2. Turn the Open/Close knob ¼ turn to the left
(counterclockwise) and open the lid.
2.
3. To program a new code, press the red reset
button on the right side of the battery box.
The LED light will flash Orange.
3.
4. Enter a new code (up to 5 digits), followed by the  key and repeat a
second time. Example: 1 - 2 - 3 - 4 - 5 -  - 1 - 2 - 3 - 4 - 5 - .
After the first set the LED will flash orange and after the second it will flash
green indicating that you have successfully reprogrammed the code.
SETUP & OPERATION
STEP 3: LOCK THE SAFE:
Close the Lid and make sure that the
Open/Close Knob is in the Locked position.
.