User`s guide

MS7580-118-EAS Model

MS7580-118-EAS models are equipped with an integrated antenna for Electronic

Article Surveillance (EAS) system support. The following information should be

used in conjunction with the manufacturer’s EAS system documentation for

successful integration of an MS7580-118-EAS Genesis.

Integrated RF EAS Antenna Connection

The following information is applicable for MS7580-118-EAS kits containing an

RS232, MX-5S000-E-3 cable or a USB, MX-5S235-E-3 cable.

1. Locate the connector cover on the

bottom of the imager’s base.

2. Remove the socket screw securing

the connector cover. A 1.5 mm hex

key is supplied.

3. Remove the connector cover plate by

lifting up () the end and sliding the

cover to the left ().

4. Insert the 2-pin box plug (A) into the

receptacle on the imager’s stand

(Figure 24).

5. Insert the cable’s strain relief (B) into

the channel on the stand (Figure 24).

6. Re-install the connector cover. Slide

the tab (C) on the cover into the

space between the box receptacle

and the stand (Figure 25).

7. Install the socket screw (D) to secure

the cover to the stand (Figure 25).

Figure 23.

Figure 24.

Figure 25.