Safe Manual

6
You may bolt your safe to a shelf / floor for added theft protection and resistance to tipping. Your safe
has (2) pre-drilled bolt-down holes in the floor panel. (2) Mounting screws are provided for securing
to wood surfaces. If bolting to concrete of metal additional hardware will be needed. Check with your
local home center.
To secure your safe to a wood shelf / floor:
1. Select a suitable and convenient location for your safe.
2. Empty the safe and remove the carpet.
3. Locate the pre-drilled holes on the inside of safe.
4. Place your safe in the desired location.
5. Line up the pre-drilled holes and mark the Shelf / floor through the holes.
6. Move the safe aside to clear marked spots for drilling.
7. Drill 2 pilot holes using a 1/8” drill bit.
8. Place the safe back over the holes and secure in place using 2 wood screws (provided).
9. Once completed, replace the carpet.
NOTE: Bolting/unbolting of the unit is at the consumer’s expense and discretion. LH Licensed
Products is not responsible for any costs incurred if the unit is to be replaced.
If you have any questions about mounting the safe, please check with your local home center/
hardware retailer or independent contractor.
ANCHORING YOUR SAFE
x2
READY
PROC
EED
LOW
BATTERY
Figure 1 Figure 2 Figure 3