Safe Manual
3
Your new safe is equipped with a digital lock that can be operated with two separate user codes. You
will need to program these user codes with your own 3-8 digit user codes. It is recommended that you
record your new user codes and keep in a secure location away from the safe. You must program the
Primary user code first. After the Primary user code is programmed and tested you can then proceed to
program the Secondary user code.
1. Push the safe door to the closed position and turn the knob counter clockwise to the left (Figure 1).
2. Enter the preset primary factory code “1 5 9” followed by # key into the keypad (Figure 2).
3. If the correct code is entered, the keypad will beep twice, and the green LED will light up. The knob
can then be turned clockwise to the right to open (Figure 3 & 4).
NOTE: You have approximately 5 seconds to open the safe. If you wait any longer, the safe will re-lock
and you must re-enter the code to open the safe.
4. To Lock, close safe door and turn knob counter clockwies to the left (Figure 5).
PROGRAMMING PRIMARY USER CODE
TESTING DIGITAL LOCK
PRIMARY & SECONDARY USER CODES
READY
PROCEED
LOW
BATTERY
READY
PROCEED
LOW
BATTERY
Figure 1
Figure 1
Figure 2
Figure 2
Figure 3
Figure 3
Figure 4 Figure 5
PROGRAM THE PRIMARY USER CODE
1. Open door using the factory preset code of 159 followed by the # key. Locate and press the red
reset button located on the inside edge of the door (Figure 1).
2. The keypad will beep twice and the yellow LED will light up (Figure 2).
3. Enter a new 3-8 digit Primary user code followed by the # key. The keypad will beep twice and
the yellow LED will turn off (Figure 3).
4. You can now close and lock the safe door and your new Primary user code is now active
(Figure 4).
READY
PROCEED
LOW
BATT
E
R
Y
READY
PROCEED
LOW
BATT
E
R
Y
READY
PROCEED
LOW
BATTERY
Figure 4
READY
PROCEED
LOW
BATT
E
R
Y