Safe Manual
For your convenience, we have included 4 “AA” batteries that provide the power for the electronic
locking system. These batteries must be installed before using your safe. The battery compartment is
located inside the safe on the lock cover panel.
Note:
If both green and red LED’s are on, it is an indicator that the batteries are weak and must be changed
immediately. The Primary and Secondary user codes will not be erased if the batteries become weak
or are removed. Weak or dead batteries should be replaced immediately and all 4 batteries should be
changed. To replace the batteries please follow STEPS 1 - 3. Remember to always remove batteries
from safe if not using for an extended period of time. If your batteries are completely dead and you
cannot open the safe by using the digital keypad, use the override access key to open safe and access
the battery compartment. The use of Non-alkaline or rechargeable batteries is NOT RECCOMMENDED.
1. Remove battery compartment cover and insert 4 “AA” batteries (included). Make sure that the
batteries are installed in the correct direction with regard to polarity (+ and -). (Figure 1 & Figure 2).
2. Replace the battery cover (Figure 3).
3. Proceed to the “Testing Digital Lock” section on next page.
2
INSTALL BATTERIES
OVERRIDE ACCESS KEY
Your safe is equipped with an override access key which allows immediate access in case you forget
your user codes or the batteries need to be installed or replaced.
1. Remove override access lock cover by gently pressing on the right edge, rotating
clockwise to the right and lifting away from key lock (Figure 1).
2. Insert the override access key into the lock until it stops (Figure 2).
3. With the key inserted turn counter clockwise to the left (Figure 3).
4. Turn knob clockwise to the right and pull safe door open (Figure 4 & Figure 5).
5. Remove override access key and store it in a safe place away from the safe. Replace the
cover over the key lock and proceed to “Install Batteries”.
READY
PROCEED
LOW
BATTERY
READY
PROCEED
LOW
BATTERY
READY
PROCEED
LOW
BATTERY
READY
PROCEED
LOW
BATTERY
READY
PROCEED
LOW
BATTERY
Figure 1
Figure 1
Figure 2
Figure 2
Figure 3
Figure 3
Figure 4 Figure 5