Home Security System User Manual
Table Of Contents
- ONYX®FirstVision™
- Fire Alarm System Limitations
- Installation Precautions
- FCC Warning
- Section 1 Introduction
- Section 2 FirstVision Installation Instructions
- Section 3 Enabling FirstVision to Monitor Your Building
- 3.1 Process Overview
- 3.2 Make Connections to FirstVision
- 3.3 Turn on Power to FirstVision
- 3.4 Set the FirstVision Clock and Time Zone
- 3.5 Establish Communication Between Your LAN and FirstVision
- 3.6 Establish Gateway Communication
- 3.7 Copy Your Exported Building Design to FirstVision
- 3.8 Display Your Building Design on FirstVision
- 3.9 Test Your Building Design on FirstVision
- 3.10 Touch Screen Calibration
- Section 4 Operating Basics of FirstVision
- 4.1 Normal Operation (No Events Being Reported)
- Figure 4.1 FirstVision Display Example: No Alarms
- Figure 4.2 FirstVision Display Example: Floor Number Button
- Figure 4.3 FirstVision Display Example: Building Information
- Figure 4.4 FirstVision Display Example: Zoomed Floor Plan
- Figure 4.5 FirstVision Display Example: Moving Through a Zoomed Floor Plan
- Figure 4.6 FirstVision Display Example: HAZMAT Information
- 4.2 Investigating Gateway Disconnection
- 4.3 Operation When a Fire Alarm is Received
- 4.4 Operation After a Fire Alarm Has Been Cleared
- 4.5 Accessing the Log File
- 4.1 Normal Operation (No Events Being Reported)
- Section 5 The Development of FirstVision
- 5.1 The Current Situation for a Firefighter
- 5.2 The Technology of FirstVision
- 5.3 Expected Firefighter Interaction with the FirstVision
- 5.3.1 Example Emergency Situations
- Figure 5.1 Fire Scene Scenario Floor Plan Information
- Figure 5.2 Fire Scene Scenario Roof Plan Information
- Figure 5.3 Fire Scene Scenario HAZMAT Information
- Figure 5.4 Fire Scene Scenario Building Information
- Figure 5.5 Example Building Site Plan Information
- Figure 5.6 Example HAZMAT Information
- Figure 5.7 Example Contact Information
- 5.3.1 Example Emergency Situations
- Index
Enabling FIRSTVISION to Monitor Your Building Establish Communication Between Your LAN and FIRSTVISION
22 FIRSTVISION™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
3.5 Establish Communication Between Your LAN and
F
IRSTVISION
The following steps are performed using Windows operations on FIRSTVISION.
Step 1. If F
IRSTVISION application is running, shut it down (ESC key on direct connect keyboard).
Step 2. Click Start >Control Panel. The Control Panel window displays.
Step 3. Double click on Network Connections. The Network Connections window displays.
Figure 3.10 Windows LAN Connection
Step 4. Right click on Local Area Connections 2 in the Network Connections window and select
Properties from the list of choices. The Local Area Connection Properties window
displays.
Step 5. On the General tab click on "Internet Protocol (TCP/IP)", then click on the Properties
button. The Internet Protocol (TCP/IP) Properties window displays.
Figure 3.11 Windows LAN Connection Properties
NOTE: A factory default IP address setting is set to: 192.168.0.4. If you need to change those
settings, then use the following information.