Installation Instructions

7
FINAL INSTALLATION
Figure 5.5
Figure 5.8
Figure 5.4
Figure 5.7
Figure 5.6
Figure 5.9
Blade Screw
Rubber Washer
Fitter Plate
Screw
Keyhole
Slot
Blade Washer
Blade Arm
Hex Nut
Blade Arm
Motor Screw
Fitter
Plate
Screw
Light Kit
9-pin Connector
Blade
Plastic Spacer
Plastic Spacer
Rubber Washer
Hex Nut
Finial Cap
Finial
4. Partially insert the blade screws along with lock washer and blade washer through blade and into the blade arm. Tighten each
blade screw starting with the one in the middle (Figure 5.4). Repeat this step for the remaining blades and blade arms (Figura 5.4).
5. Remove the 10 motor screws from the underside of the motor assembly. Then, install the blade arms to the underside of the
motor assembly using the ten previously removed motor screws (Figure 5.5).
6. Remove one of the three fitter plate screws from the fitter plate and loosen the other two. Ensure the connectors are secure.
Then, connect the 9-pin connector from the fan to the 9-pin connector from the light kit.
7. Lift the light kit and place the two keyhole slots in the light kit over the two loosened fitter plate screws. Turn the light kit
clockwise and secure it to the fitter plate with the previously removed fitter plate screw. Tighten all three screws (Figure 5.7).
8. Remove the finial, finial cap, hex nut, plastic spacer and rubber washer from the threaded rod at the bottom of the light kit.
Install the three E26-base bulbs into the sockets of the light kit (Figure 5.8).
9. Lift the ribbed glass up until the top edge is seated in the top rim of the light kit. Feed the pull chain through the rubber
washer and plastic spacer and secure with hex nut. Note: The concave side of the plastic spacer will face downward so that
the hex nut will fit inside (Figure 5.9).