Installation Guide

69-1371-1 G.H. 9-03 www.honeywell.com/yourhome
Automation and Control Solutions
Honeywell International, Inc. Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MN 55422 Scarborough, Ontario
M1V 4Z0
4074FAB
Fig. 3. Connect resistor across terminals W
and B on Trane electric heat air handlers.
Fig. 4. Connect resistor to R8184
Oil Primary terminals T and F.
Fig. 5. Connect resistor for cool only application.
CHECKOUT
1. Set the thermostat heating setpoint to 10°F (6°C)
above the room temperature.
2. Watch the thermostat display for approximately
five minutes to be sure the display does not go
blank during the call for heat.
3. Reset the thermostat to a comfortable setpoint.
DISCONNECT POWER SUPPLY BEFORE INSTALLATION.
1
1
M16653
W TERMINAL B TERMINAL
(OPTIONAL)
TO THERMOSTAT
TE R M I NA L B O ARD C O NN E C TIO N
1
2
2
R8184G
T
T
F
F
RESET
DISCONNECT POWER SUPPLY BEFORE INSTALLATION.
BE SURE RESISTOR IS MOUNTED ON LOWER
T AND F TERMINALS.
1
M16651
RY W
POWER SUPPLY. PROVIDE DISCONNECT MEANS
AND OVERLOAD PROTECTION AS REQUIRED.
1
M16652
L1
(HOT)
L2
1
COMPRESSOR
CONTACTOR
4074FAB