User's Manual

3800g/3800gHD/3800gPDF User’s Guide 7 - 15

Code 128 Message Length

Scan the bar codes below to change the message length. Refer to Message

Length on page 7-2 for additional information. Minimum and Maximum

lengths = 0-80. Minimum Default = 0, Maximum Default = 80.

Code 128 Code Page

Code pages define the mapping of character codes to characters. If the data

received does not display with the proper characters, it may be because the bar

code being scanned was created using a code page that is different from the

one the host program is expecting. If this is the case, scan the bar code below,

select the code page with which the bar codes were created from the chart,

Code Page Mapping of Printed Bar Codes on page A-4, and scan the value and

the SAVE bar code from the Programming Chart inside the back cover of this

manual. The data characters should then appear properly.

Code 128 Function Code Transmit

By default, Code 128 function codes are not transmitted with Code 128 bar

code data. However, if you wish to transmit Code 128 function codes with the

bar code data, scan the Function Codes On bar code, below.

Telepen

Minimum Message Length

Maximum Message Length

Code 128 Code Page

* Function Codes Off

Function Codes On