User's Manual

3800g/3800gHD/3800gPDF User’s Guide 7 - 35
UPC/EAN Version
Scan the UPC/EAN Version On barcode to decode GS1 Composite symbols
that have a UPC or EAN linear component. (This does not affect GS1 Compos-
ite symbols with a GS1-128 or GS1linear component. If either of these codes
are the linear component, either Code 128 or the correct GS1 code must be
enabled.)
GS1 Composite Code Message Length
Scan the barcodes below to change the message length. Refer to Message
Length (page 7-2) for additional information. Minimum and Maximum lengths =
1-2435. Minimum Default = 1, Maximum Default = 2435.
GS1 Emulation
The imager can automatically format the output from any GS1 data carrier to
emulate what would be encoded in an equivalent GS1-128 or GS1 DataBar
symbol. GS1 data carriers include UPC-A and UPC-E, EAN-13 and EAN-8,
ITF-14, GS1-128, and GS1-128 DataBar and GS1Composites. If GS1-128
Emulation is selected, the AIM Symbology Identifier will be reported as “]C1”. If
GS1 DataBar Emulation is selected, the AIM Symbology Identifier will be
reported as “]e0.” Any application that accepts GS1 data can be simplified
since it only needs to recognize one data carrier type.
Default = GS1 Emulation
Off
.
UPC/EAN Version On
* UPC/EAN Version Off
Maximum Message Length
Minimum Message Length
GS1 Data Bar Emulation
GS1-128 Emulation
* GS1 Emulation Off