Safe Manual

LOCKING STORAGE BOX

This safe includes a built-in storage-box. It can be used to place accessories,

hand guns, ammo and many other personal items.

To open:

Insert supplied key and turn fully to the right and pull door open.

To close:

Push door to closed position, turn key fully to the left until it stops. The door is

now in the locked position. Remove key and store in a safe place.

Note: If storage box replacement keys are needed please refer to page 4 of this

manual. You will need the key number which is a 4 digit number etched on the

metal collar located around the key hole.

MOUNTING KIT

You may bolt your safe to the wall or floor to added theft protection and

resistance to tipping.

Your safe has pre-drilled bolt-down holes in the back panel and in the floor.

To secure your safe to the wall and/or floor:

1. Select a suitable and convenient location for your safe.

2. Empty the safe and remove the carpet.

3. Locate the predrilled holes on the inside of safe.

4. Place your safe in the desired location.

5. Line up the predrilled holes and mark the floor or wall through the holes.

NOTE: It is not recommended to attempt to bolt to both floor and wall.

6. Move the safe aside to clear marked spots for drilling.

7. Drill holes appropriate for hardware being used and the mounting

surface. INCLUDED: (2 each – bolts, washers and masonry anchors).

8. Place the safe back over the holes and install the fasteners as required.

9. Once completed, replace the carpet.

NOTE: Bolting/unbolting of the unit is at the consumer’s expense and

discretion. LH Licensed Products is not responsible for any costs incurred if

the unit is to be replaced.

If you have any questions about mounting the safe, please check with your

local home center/hardware retailer or independent contractor.