Safe Manual

2
SETUP
STEP1. OPEN SAFE WITH OVERRIDE KEY
1. Remove override key cover with small screwdriver.
2. Insert override key and turn left to unlock safe.
3. Turn knob to right (clockwise) and unlock safe
4. Turn lever to right (counter clockwise) to disengage the bolts
and open door.
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover on inside door. Insert 4
“AA” batteries (included). Ensure the batteries are installed in
the correct direction, with regard to polarity (+ and -).
2. Replace the battery cover.
3. Do not close door before testing digital lock.
STEP 3. TEST DIGITAL LOCK
1. With door open, turn knob left to put locking door bolts in lock
position.
2. Remove override key and store in a secure place.
NEVER STORE KEYS INSIDE SAFE!
3. Enter the preset pass code: “1”-“5”–“9”-“B”.
4. Turn knob to right within 5 seconds.
5. Lock bolts should recede into the unlocked position.
STEP 4. PROGRAM A NEW PASSCODE
1. With door open, press reset button (C) inside door.
2. Yellow light is on, enter new pass code in 30 seconds.
3. Enter new code (3 to 8 digits) followed by “A” or “B”.
4. Safe will beep and yellow light will turn off. Lock bolts should
recede into the unlocked position.
NOTE: The factory pre-set code will not work after a new pass code is programmed.
OPERATION
TO OPEN THE SAFE
1. To unlock and open safe, enter the pass code
followed by “A” or “B”.
2. Turn knob to right (clockwise) and unlock safe.
3. Turn lever to right (counter clockwise) to
disengage the bolts and open.
TO CLOSE THE SAFE
1. Close the door and hold it in the closed position.
2. Turn lever to left (clockwise) to engage the bolts
and secure door.
3. Turn knob to the left (counter clockwise) and lock
safe.