User Guide
Table Of Contents
- 1. General
- 2. LonWorks C4 Option Board Technical Data
- 3. LonWorks Fieldbus C4 Option Board Layout and Connections
- 4. Installation of Honeywell NX LonWorks C4 Option Board
- 5. Commissioning
- 6. LonWorks Interface
- 7. Fault Tracking
- 8. Appendix 1
- 9. General Info
- 10. BACnet CJ Option Board Technical data
- 11. Bacnet Fieldbus CJ Option Board Layout and Connections
- 12. Grounding Cable Shield
- 13. Led Indications
- 14. Installation of Honeywell NX BACnet CJ Option Board
- 15. Commissioning
- 16. Fault Tracking
46 BACnet Commissioning Honeywell
15.3.5 Communication Status (V7.X.2.1)
To see the present status of the RS-485 fieldbus, enter the Comm.Status page from Monitor
menu (G7.5.2). See Figure 25 and Table 21 below.
Figure 25. Communication status
Good messages
0…999 Number of messages received without
communication errors
Bad Frames
0…64 Number of messages received with
CRC or parity errors
Table 21. BACnet message indications
15.3.6 Baud Rate (V7.x.2.2)
Shows the actual baud rate.
15.3.7 Fault (V7.x.2.3)
Shows BACnet fault codes. See Table 24 from Chapter 16.
15.3.8 Index Nr. (V7.x.2.4)
Shows the Device Object's Instance number.
15.4 Annex - Protocol Implementation Conformance Statement (Normative)
(This annex is part of this Standard and is required for its use.)
BACnet Protocol Implementation Conformance Statement
Date: May 31, 2005
Vendor Name: Honeywell
Product Name: Honeywell Drive – xxx (xxx = MAC ID)
Product Model Number: OPTCJ
Applications Software Version: 10522 Firmware Revision: 1 BACnet Protocol
Revision: 4