User Guide
Table Of Contents
- 1. General
- 2. LonWorks C4 Option Board Technical Data
- 3. LonWorks Fieldbus C4 Option Board Layout and Connections
- 4. Installation of Honeywell NX LonWorks C4 Option Board
- 5. Commissioning
- 6. LonWorks Interface
- 7. Fault Tracking
- 8. Appendix 1
- 9. General Info
- 10. BACnet CJ Option Board Technical data
- 11. Bacnet Fieldbus CJ Option Board Layout and Connections
- 12. Grounding Cable Shield
- 13. Led Indications
- 14. Installation of Honeywell NX BACnet CJ Option Board
- 15. Commissioning
- 16. Fault Tracking
14 Installation of Lonworks Board Honeywell
4. Installation of Honeywell NX LonWorks C4 Option Board
!
NOTE
MAKE SURE THAT THE FREQUENCY CONVERTER IS SWITCHED
OFF BEFORE AN OPTION OR FIELDBUS C4 OPTION BOARD IS
CHANGED OR ADDED!
A
Honeywell NX frequency converter
B
Remove the cable cover.
C
Open the cover of the control unit.
Continues on next page