Instruction Manual

ManualsBrandsHoneywell ManualsCover PlateHoneywell Honeywell 32003796-001 Cover Plate

Table Of Contents

INSTALLATION INSTRUCTIONS

69-1721EFS-02

32003796-001 Cover Plate

APPLICATION

The 32003796-001Cover Plate is used to cover

marks left on the wall by the old thermostat. It can be

used with the VisionPRO™ TH8000 Series

Thermostats.

Installation

When Installing this Product...

1. Read these instructions carefully.

2. Installer must be a trained, experienced service

technician.

CAUTION

Electrical Hazard.

Can cause electrical shock or equipment

damage.

Disconnect power supply before starting

installation.

Mounting

The Cover Plate can be mounted on the wall when

mounting with a TH8000 Series Thermostat. See

Fig. 1 for dimensions.

1. Use Cover Plate to mark and drill holes; install

anchors, if necessary.

2. Pull wire through Cover Plate and thermostat

wallplate wiring opening.

3. Align Cover Plate and thermostat wallplate with

the holes. Insert the screws included with the

thermostat; then level and tighten the screws.

See Fig. 2.

Fig. 1. 32003796-001 Cover Plate dimensions.

7-7/8 (200)

3-5/16 (84)

3-5/16

(84)

M22139

5-1/2

(140)

Summary of content (8 pages)

PAGE 1
32003796-001 Cover Plate INSTALLATION INSTRUCTIONS APPLICATION The 32003796-001Cover Plate is used to cover marks left on the wall by the old thermostat. It can be used with the VisionPRO™ TH8000 Series Thermostats. Installation 1. 2. 3. Use Cover Plate to mark and drill holes; install anchors, if necessary. Pull wire through Cover Plate and thermostat wallplate wiring opening. Align Cover Plate and thermostat wallplate with the holes.
PAGE 2
32003796-001 COVER PLATE OPTIONAL MOUNTING HOLE LOCATION WIRES THROUGH WALL OPENING 32003796 COVER PLATE WALL ANCHORS (2) TH8000 SUBBASE UP UP MOUNTING SCREWS (2) OPTIONAL MOUNTING HOLE LOCATION REMOVE DURING INSTALLATION TH8000 SERIES THERMOSTAT M22138A Fig. 2. Attaching TH8000 Series Thermostat, Subbase and 32003796 Cover Plate to the wall. www.resideo.com Resideo Technologies, Inc. 1985 Douglas Drive North, Golden Valley, MN 55422 1-800-468-1502 69-1721EFS—02 M.S. Rev.
PAGE 3
PLAQUE DE RECOUVREMENT 32003796-001 NOTICE D'INSTALLATION APPLICATION 1. La plaque de recouvrement 32003796-001 sert à camoufler les marques laissées sur le mur par l’ancien thermostat. Elle peut être utilisée avec les thermostats VisionPROMC TH8000. 2. Installation Avant d’installer ce produit... 1. 2. 3. Utiliser la plaque de recouvrement pour marquer les ouvertures, puis percer les ouvertures; poser des chevilles d’ancrage au besoin.
PAGE 4
PLAQUE DE RECOUVREMENT 32003796-001 EMPLACEMENT OPTIONNEL DE L'OUVERTURE DE FIXATION FILS À TRAVERS LE MUR ET L'OUVERTURE PLAQUE DE RECOUVREMENT 32003796 CHEVILLES D'ANCRAGE (2) PLAQUE DE COMMUTATION DU TH8000 UP UP VIS DE FIXATION (2) EMPLACEMENT OPTIONNEL DE L'OUVERTURE DE FIXATION REMOVE DURING INSTALLATION THERMOSTAT TH8000 MF22138A Fig. 2. Installation au mur d’un thermostat TH8000, d’une plaque de commutation et d’une plaque de recouvrement 32003796. www.resideo.
PAGE 5
32003796-001 Placa INSTRUCCIONES DE INSTALACIÓN APLICACIÓN La placa 32003796-001 se utiliza para cubrir las marcas dejadas en la pared por el termostato antiguo. Se puede usar con los termostatos VisionPRO™ Serie TH8000. Instalación 1. Si es necesario, utilice la placa para marcar y perforar los orificios e instalar las anclas/taquetes. 2. Tire del cable a través de la placa y la abertura para cableado en la placa de pared del termostato. 3.
PAGE 6
32003796-001 PLACA UBICACION DEL ORIFICIO DE MONTAJE OPCIONAL CABLES POR EL ORIFICIO EN LA PARED PLACA 32003796 ANCLAS/ TAQUETES (2) SUBBASE TH8000 UP UP TORNILLOS DE MONTAJE (2) UBICACION DEL ORIFICIO DE MONTAJE OPCIONAL REMOVE DURING INSTALLATION TERMOSTATO SERIE TH8000 Fig. 2. Cómo fijar el termostato Serie TH8000, la subbase y la placa 32003796 a la pared.
PAGE 7
32003796-001 PLACA 3 69-1721EFS—02
PAGE 8
32003796-001 PLACA www.resideo.com Resideo Technologies, Inc. 1985 Douglas Drive North, Golden Valley, MN 55422 1-800-468-1502 69-1721EFS—02 M.S. Rev. 01-20 | Impreso en EE. UU. ©2020 Resideo Technologies, Inc. All rights reserved. The Honeywell Home trademark is used under license from Honeywell International, Inc. This product is manufactured by Resideo Technologies, Inc. and its affiliates. Tous droits réservés.