Install Instructions

INSTALLATION INSTRUCTIONS
66-1117
® U.S. Registered Trademark
Copyright © 2000 Honeywell Inc. • All Rights Reserved
32003039-001
Position Indication Lamp Kit
APPLICATION
the 32003039-001 Position Indication Lamp Kit, when
installed in the C6097A,B Pressure Switch, provides a lighted
indication when the pressure switch opens.
CONTENTS
The kit consists of a plastic bag containing the following parts
(see Fig. 1):
1.
Lamp and wires.
2.
Terminal plate.
3.
Captive screw and nut.
4.
Screw.
Fig. 1. 32003039-001 Position Indication Lamp Kit.
INSTALLATION
WARNING
Explosion or Fire Hazard.
Can cause severe personal injury, death or
property damage.
Observe all safety requirements each time a control is
installed on a burner.
When Installing this Product...
1.
Read these instructions carefully. Failure to follow them
can damage the product or cause a hazardous
condition.
2.
Check the ratings given in the instructions and on the
product to make sure the product is suitable for your
application.
3.
Installer must be a trained, experienced flame
safeguard service technician.
4.
After installation is complete, check out product
operation as provided in these instructions.
WARNING
Electrical Shock Hazard.
Can cause serious personal injury or death.
Disconnect power supply before beginning installation.
More than one disconnect can be involved.
Installing the Position Indication Lamp Kit
(See Fig. 2)
1.
Remove the cover from the C6097 by removing the
screws in the upper left and lower right quadrants of the
cover.
2.
Place the lamp in the slot to the right of the dial, in the
upper right-hand corner of the C6097, with the base of
the lamp down.
3.
Run the two lamp wires through the slit in the upper left
corner of the lamp slot.
4.
Place the nut in the hexagonal depression in the lower
left-hand corner of the C6097.
5.
Place the terminal plate over the nut and fasten the ter-
minal plate to the C6097 with the screw through the bot-
tom hole in the terminal plate.
6.
Place the captive screw through the terminal lug on the
shorter wire and fasten the wire to the terminal plate
with the captive screw secured by the nut under the
terminal plate.
7.
Using Fig. 3 or 4 for reference, fasten the terminal lug
on the longer lamp wire to either the normally open (NO)
or normally closed (NC) terminal of the C6097.
8.
Replace the C6097 cover and secure with the screws
removed in step 1.
1-19/32 (40)
3-11/32 (85)
4-1/8 (105)
1/2
(13)
1/4 (6)
LAMP AND WIRES
TERMINAL
PLATE
CAPTIVE SCREW
AND NUT
SCREW
M16523