Safe Manual

8
CLIMATE MONITORING
TEMPERATURE AND HUMIDITY GAUGE
For your convenience and added
protection of your safe’s contents,
this safe is equipped with a
hygrometer that continually
monitors and displays the interior
temperature and humidity on an
LED Display panel located above
the left side of the door.
Depending on the geographic location of your safe, excess humidity may be a problem
that can cause damage to the contents. For this reason, it is recommended that you
open your safe on a regular basis, especially if you live in an area of high humidity.
Additionally, it is recommended that you keep important paperwork in airtight zip lock
type bags. This will prevent damage should moisture accumulate, especially in airtight
fire and waterproof safes.
HOW TO TURN ON BACK LIGHT
The back light makes it easier to read the gauge in low light environments. You can
activate the back light by pressing the button located on the bottom at right side of the
LED display.
CELSIUS OR FAHRENHEIT
You can change the temperature display to show the temperature in either Celsius or
Fahrenheit by pressing the button located on the top at right side of the LED display.
HOW TO CHANGE BATTERY
The LED Humidity / Temperature gauge operates
on a single AAA battery. You must replace the
battery if it becomes low or dead.
1. Remove the LED Display from the safe by lifting
the edges and pulling out.
2. Remove the Battery Cover by pressing on the
left side and sliding the cover to the right until it
can be lifted off.
3. Replace the “AAA” battery and place cover back
over the battery compartment.
4. Replace the LED Display Panel in the safe.