Safe Manual

OPENING/CLOSING SAFE WITH USER CODES

1. Make sure the spindle handle is positioned to the left and enter your new user

code into the keypad followed by the # key.

2. The keypad will beep once, green LED will light up and the lock will click. Turn the

handle clockwise to the right to open the safe.

3. To lock, close the door and turn the spindle handle counterclockwise to the left.

LOST OR FORGOTTEN USER CODES

LOSS OF PRIMARY USER CODE

If the 3-8 digit Primary user code is lost or forgotten you can enter a new 3-8 digit

Primary user code by opening the safe with the 3-8 digit secondary user code and

using red reset button located on the inside edge of the door.

Once the safe is open follow the instruction on how to “REPROGRAM A NEW

PRIMARY USER CODE” located at the bottom of page 1

LOSS OF SECONDARY USER CODE

If the 3-8 digit Secondary user code is lost or forgotten you will not be able to

reprogram a new Secondary user code.

You will be able to continue using the safe with the 3-8 digit Primary user code but

will lose the ability to have a Secondary user code.

IMPORTANT: To avoid losing the ability to continue using a Secondary user code it

is very important that the 3-8 digit Secondary user code is recorded when it is

programmed and kept in a secure location away from the safe.

LOSS OF BOTH PRIMARY AND SECONDARY USER CODES

If both the Primary user code and Secondary user codes are lost, you may open

the safe using the Emergency Override Access key and use the red user code reset

button to reprogram the 3-8 digit Primary user code.

The instructions for opening the safe with the Emergency Override Access key are

below.