Safe Manual

SECONDARY USER CODE
PROGRAM THE SECONDARY USER CODE
Once you have successfully programmed the Primary user code, you can proceed to
programming the Secondary user code. The Secondary user code is programmed
using the Digital Keypad and it is not necessary to open the safe to proceed.
1. Using the keypad, press the ! button twice (!-!)
2. Enter the factory default user code 1-2-3-4-5-6 followed by the # key into the
keypad.
3. The green LED with light up once and the keypad will beep twice.
4. Enter a new 3-8 digit Secondary user code followed by the # key and the green
LED will again light up and the keypad will beep.
5. Immediately re-enter the new 3-8 digit Secondary user code a second time
followed by the # key and the green LED will flash twice and the keypad will beep
twice.
6. After the new secondary user code is programmed, the factory preset user code
will be erased and the safe can only be unlocked using your new Primary or
Secondary user codes.
IMPORTANT: To change the secondary user code, the current user code will be
required. For this reason, it is very important that it is recorded and kept in a
secure location away from the safe.
TEST THE SECONDARY USER CODE
1. With door open, rotate handle counterclockwise to put door bolts in lock position.
2. Enter the new 3-8 digit Secondary user code followed by the # key. The green
LED will light up and the keypad will beep.
3. Rotate handle clockwise within 5 seconds.
4. The lock bolts should recede into the unlocked position when the handle is turned.
REPROGRAM A NEW SECONDARY USER CODE
1. Using the keypad, press the ! button twice (!-!)
2. Enter the current 3-8 digit Secondary user code followed by the # key into the
keypad.
3. The green LED with light up once and the keypad will beep twice.
4. Enter a new 3-8 digit secondary user code followed by the # key and the green
LED will again light up and the keypad will beep.
5. Immediately re-enter the new 3-8 digit secondary user code a second time
followed by the # key and the green LED will flash twice and the keypad will beep
twice.